Caterpillar D10T/D10T2 Track-Type Tractors Factory Service & Shop Manual

Download Link

INSTANT DOWNLOAD (add to cart)

Complete workshop & service manual with electrical wiring diagrams for Caterpillar D10T/D10T2 Track-Type Tractors. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Caterpillar D10T/D10T2 Track-Type Tractors service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

UENR7133 – Schematic (D10T Track-Type Tractor Remote Control Gen 3 Phase VI Electrical System)
KENR5629 – Disassembly & Assembly (D10T2 Track-Type Tractor Engine Supplement)
KENR5631 – Specifications (D10T2 Track-Type Tractor Systems)
KENR5631 – Systems Operation (D10T2 Track-Type Tractor Systems)
KENR5631 – Testing & Adjusting (D10T2 Track-Type Tractor Systems)
KENR5632 – Schematic (D10T2 Track-Type Tractor Cooling System)
KENR5633 – Disassembly & Assembly (D10T2 Track-Type Tractor Power Train)
KENR5638 – Disassembly & Assembly (D10T2 Track-Type Tractor Machine Systems)
KENR5639 – Schematic (D10T2 Track-Type Tractor Electrical System, Cab and Chassis Wiring 375-6455, Engine (for SN JJW1-186))
UENR0089 – Schematic (D10T2 Track-Type Tractor Power Train System)
UENR0090 – Schematic (D10T2 Track-Type Tractor Hydraulic System)
UENR4159 – Systems Operation (D10T2 Track-Type Tractor Automatic Lubrication System)
UENR4159 – Testing & Adjusting (D10T2 Track-Type Tractor Automatic Lubrication System)
UENR4176 – Schematic D10T2 (Track-Type Tractor Electrical System (for SN RAB313-UP & JJW205-UP))
UENR6979 – Schematic (Track-Type Tractor Command for Dozing Remote Control Operator Station Electrical System)
UENR7109 – Schematic (D10T2 Track-Type Tractor Electrical System (for SN RAB282-312 & JJW187-204))

7. Raise the temperature of bearing cone (19). Install bearing cone (19).
8. Attach Tooling (C) and a suitable lifting device onto gear assembly (18). The weight of gear assembly (18) is approximately 45 kg (100 lb). Install gear assembly (18).
9. Do not allow Tooling (C) to catch on the tube assemblies that are located below gear assembly (18). Remove Tooling (C).