Posted on

Hitachi EX1000, EX1100 Excavator Factory Service & Shop Manual


Pages from W142E00 – Hitachi EX1100-3 Excavator Workshop Manual

MHITEX1100OPES.zip
Price: $29.99 USD

Complete workshop & service manual with electrical wiring diagrams for Hitachi EX1000, EX1100, EX1100-3 Excavator. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This Hitachi EX1000, EX1100, EX1100-3 Excavator service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

FILELIST:
KM123E01 – Hitachi EX1100 Excavator Technical Shop Manual (Service & Repair).pdf
KM10700 – Hitachi EX1000 Excavator Technical Shop Manual (Service & Repair) 1 of 2.pdf
KM10700 – Hitachi EX1000 Excavator Technical Shop Manual (Service & Repair) 2 of 2.pdf
T142E00 – Hitachi EX1100-3 Excavator Technical Manual.pdf
TO18EE-00 – Hitachi EX1200-5C Excavator Technical Manual (Operational Principle).pdf
W142E00 – Hitachi EX1100-3 Excavator Workshop Manual.pdf
EM17E21 – Hitachi EX1100-3 Excavator Operator’s Manual.pdf
EM178EN17 – Hitachi EX1100 Excavator Operator’s Manual.pdf
EM17818 – Hitachi EX1100 Excavator Operator’s Manual.pdf
Hitachi EX1200 5 & 6 Excavator Pin & Buses.pdf

EXCERPT:
UPPERSTRUCTURE / Pilot Shut-off Valve
Disassemble Pilot Shut-Off Valve
Be sure to thoroughly read Precautions for Disassembly and Assembly on page W01-01-01 before starting disassembly.
1. Remove retaining ring (1) and washer (2) and pull out spool (11).
2. Remove spring pin (9) from spool (11), then remove lever (10).
NOTE: Mark spool (11) and lever (10) for alignment when installing.
3. Remove washer (7), retaining ring (8) from spool (11).
4. Remove backup rings (3), (6), O-ring (4) and (5) from body (14).