Complete workshop & service manual with electrical wiring diagrams for Ford Focus 2012-2013. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This Ford Focus 2012-2013 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
· P3E – 4-door sedan, S series
· P3F – 4-door sedan, SE series
· P3H – 4-door sedan, SEL series
· P3J – 4-door sedan, Titanium series
· P3K – 5-door hatchback, SE series
· P3L – 5-door hatchback, ST series
· P3M – 5-door hatchback, SEL series
· P3N – 5-door hatchback, Titanium series
· 2 – 2.0L, in-line 4-cylinder, 16-valve
· 9 – 2.0L GTDI (gasoline turbo-charged direct injection)
EXCERPT:
2012 – 2013 Focus
Workshop Manual
Specifications
Metrics
Torque Wrench Adapter Formulas
Alphabetical Index
1: General Information
00: Service Information
2: Chassis
04: Suspension
05: Driveline
06: Brake System
11: Steering System
3: Powertrain
03: Engine
07: Automatic Transmission
08: Manual Transmission, Clutch and Transfer Case
09: Exhaust System
10: Fuel System – General Information
4: Electrical
12: Climate Control System
13: Instrumentation and Warning Systems
14: Battery and Charging System
15: Information and Entertainment Systems
17: Lighting
18: Electrical Distribution
19: Electronic Feature Group
5: Body and Paint
01: Body and Paint
02: Frame and Mounting
…
Engine – Overview
Engine Information
NOTE: When repairing engines, all parts must be contamination free. If contamination/foreign material is present when repairing an engine, premature engine failure may occur.
NOTE: Specifications show the expected minimum or maximum condition. Refer to the appropriate section in Group 303 for the specifications.
NOTE: If a component fails to meet the specifications, it is necessary to refinish it or install a new component. Wear limits are provided as an aid to determine if the component can be refinished. A new component must be installed when any component fails to meet specifications and cannot be refinished.
NOTE: This section contains information, steps and procedures that may not be specific to this engine.
This section covers general procedures and diagnosis and testing of the engine system, except for exhaust emission control devices, which are covered in the PC/ED.
The engine incorporates the following features: Refer to the appropriate section in Group 303 for the procedure.
· Crankcase ventilation or breather system
· Exhaust emission control system
· EVAP control system
…