Pages from 327258010 – AGCO-Fendt 5250 L, 5250 L-AL, 6250 L, 6270 L Workshop Manual
Complete workshop & service manual with electrical wiring diagrams for AGCO/Fendt 5250 L, 5250 L-AL, 6250 L, 6270 L. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This AGCO/Fendt 5250 L, 5250 L-AL, 6250 L, 6270 L service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
FILELIST:
327230012 – AGCO/Fendt 5250 L, 5250 L-AL, 6250 L, 6270 L Operator’s Manual.pdf
327258010 – AGCO/Fendt 5250 L, 5250 L-AL, 6250 L, 6270 L Workshop Manual.pdf
EXCERPT:
TABLE OF CONTENTS
Sections
– GENERAL INFORMATION … 00
– ENGINE … 10
– LIVE PTO … 14
– TRANSMISSION …. 21
– FRONT DRIVE AXLE … 25
– HYDROSTATIC TRANSMISSION …. 29
– BRAKES AND CONTROL … 33
– HYDRAULIC SYSTEMS … 35
– STEERING … 41
– AXLE AND WHEELS …. 44
– CAB CONDITIONING SYSTEM … 50
– ELECTRICAL SYSTEMS … 55
– ATTACHMENTS / HEADERS … 58
– PRODUCT FEEDING … 60
– THRESHING … 66
– SEPARATION …. 72
– STRAW CHOPPER …. 73
– CLEANING … 74
– GRAIN STORAGE …. 80
…
SECTION 25 – FRONT MECHANICAL DRIVE
Engage the spacer (20) on the wheel axle, with the bevelled edge upwards (outer side).
After lubricating the housing, fit the wheel axle inner bearing using a suitably-sized drift.
Engage the special tool (21) re. 51 013 (see dimensions on page 6) to lock the pinion movement.
Screw the ring nut on the wheel axle, tightening at the torque of 400/500 Nm, using the special wrench (22)
re. 296124.
Remove the tool (21) to make the housing rotate by 3/4 turns, then position it again.
Loosen the ring nut, then tighten it again at 300 Nm.
Engage the lock washer (23).
…