Pages from D3151800 M1 – AGCO-Fendt 8370 P, 8400 P Combine Range + Auto Level + Rotary Separator Workshop Service Manual
Complete workshop & service manual with electrical wiring diagrams for AGCO/Fendt 8370 P, 8400 P Combine Range + Auto Level + Rotary Separator. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This AGCO/Fendt 8370 P, 8400 P Combine Range + Auto Level + Rotary Separator service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
FILELIST:
D3151100 M1 – AGCO/Fendt 8370 P, 8400 P + Auto Level + Rotary Separator Operator’s Manual.pdf
D3151800 M1 – AGCO/Fendt 8370 P, 8400 P Combine Range + Auto Level + Rotary Separator Workshop Service Manual.pdf
EXCERPT:
Table of Contents
0 Introduction – Specifications
1 Cutting table
2 Reel
3 Main crop elevator
4 Threshing unit
5 Straw walkers
6 Shaker shoe- Fanning mill
7 Elevators
8 Engine
9 Unloading auger – Grain tank
10 Drive unit
11 Transmissions
12 Undercarriage
13 Cab
14 Hydraulics
15 Machine housing
16 Electrical system (draft)
17 Straw chopper
18 General assembly instructions
19 Miscellaneous data
…
13.Cab
13.2 Replacing the windscreen
IMPORTANT: The windscreen is glued into the cab and it is advisable to have an expert workshop carry out the replacement. The new windscreen comes with a fitting kit containing the necessary materials, detailed fitting instructions and safety precautions.
1. Dismount the outer roof as described in section 13.4 on page 326.
2. Remove the screws and take off the lamp body on both sides.
3. Remove the screws, including the ones on the back (A), and take the front guard off.
4. Remove the wiper arms.
5. Replace the windscreen in accordance with the fitting instructions provided.
…