Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 1986-2006 BMW 325, 325i, 325is, 325iX, 325Ci, 325xi, 325e, 325es. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.
This manual for 1986-2006 BMW 325, 325i, 325is, 325iX, 325Ci, 325xi, 325e, 325es is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.
325: 1986-1988
325i: 1987-2006
325is: 1987-1990
325iX: 1988-1991
325Ci: 2001-2006
325xi: 2001-2006
325e: 1984-1987
325es: 1986-1987
EXCERPT:
2006-08 ENGINE Engine and Gearbox Suspension – Repair Instructions – 325i, 325xi, 330i, 330xi, Z4
2006-08 ENGINE
Engine and Gearbox Suspension – Repair Instructions – 325i, 325xi, 330i, 330xi, Z4
11 ENGINE SUSPENSION
22 11 001 REPLACING RIGHT ENGINE MOUNT (N51/N52)
Necessary preliminary tasks:
Secure engine in installation position.
Remove underbody protection.
Release screws (1) and remove engine mount.
Tightening torque 22 11 1AZ.
Fig. 1: Identifying Engine Mount
Installation:
Rubber section (1) of engine mount must point to middle of vehicle.
Engine mount designations:
Right engine mount
Even component number
Left engine mount
Odd component number
Fig. 2: Identifying Rubber Section Of Engine Mount
22 11 011 REPLACING LEFT ENGINE MOUNT (N51/N52)
Necessary preliminary tasks:
Secure engine in installation position.
Remove underbody protection.
Remove stiffening strut (1) (E90/91).
Release screws (2) and remove engine mount.
Tightening torque 22 11 1AZ.
Fig. 3: Identifying Stiffening Strut And Screws
Installation:
Rubber section (1) of engine mount must point to middle of vehicle.
Engine mount designations:
Right engine mount
Even component number
Left engine mount
Odd component number
Fig. 4: Identifying Rubber Section Of Engine Mount
22 11 100 REPLACING RIGHT ENGINE SUPPORT ARM (N51/N52)
Necessary preliminary tasks:
Remove right engine mount.
Unfasten screws.
Remove engine support arm from engine.
Installation:
Aluminium screws/bolts must be replaced.
…