Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 1996-2016 BMW 328i/328xi/328is/328Ci. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.
This manual for 1996-2016 BMW 328i/328xi/328is/328Ci is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.
328i: 1996-2016
328xi: 2007-2008
328is: 1996-1999
328Ci: 2000
EXCERPT:
ENGINE Engine and Gearbox Suspension – Repair Instructions
ENGINE
Engine and Gearbox Suspension – Repair Instructions
ENGINE MOUNTING
22 11 001 REPLACING RIGHT ENGINE MOUNT (N51/N52/N52K/N53)
Necessary preliminary tasks:
Secure engine in Installation Position .
Remove underbody protection.
Remove right V-strut (E93 only).
Release screws (1) and remove engine mount.
For tightening torque refer to 22 11 1AZ in 22 11 ENGINE SUSPENSION .
Fig. 1: Identifying Engine Mount Screws
Installation:
Rubber section (1) of engine mount must point to middle of vehicle.
Engine mount designations:
Right engine mount
Even component number
Left engine mount
Odd component number
Fig. 2: Identifying Rubber Section Of Engine Mount
22 11 011 REPLACING LEFT ENGINE MOUNT (N51/N52/N52K/N53)
Necessary preliminary tasks:
Secure engine in Installation Position .
Remove underbody protection.
Remove Reinforcement Strut (E90/91/92).
Remove left V-strut (E93 only)
Remove stiffening strut (1) (E90/91).
Release screws (2) and remove engine mount.
For tightening torque refer to 22 11 1AZ in 22 11 ENGINE SUSPENSION .
NOTE: Illustration similar
Fig. 3: Identifying Engine Mount Screws And Stiffening Strut
Installation:
Rubber section (1) of engine mount must point to middle of vehicle.
Engine mount designations:
Right engine mount
Even component number
Left engine mount
Odd component number
Fig. 4: Identifying Engine Mount Rubber Section
22 11 100 REPLACING RIGHT ENGINE SUPPORT ARM (N51/N52/N52K/N53)
Necessary preliminary tasks:
Remove Right Engine Mount.
Unfasten screws.
Remove engine support arm from engine.
Installation:
Aluminium screws/bolts must be replaced.
For tightening torque refer to 22 11 3AZ in 22 11 ENGINE SUSPENSION
Fig. 5: Identifying Engine Support Arm Screws
22 11 110 REPLACING LEFT ENGINE SUPPORT ARM (N51/N52/N52K/N53)
Necessary preliminary tasks:
Remove underbody protection at front and rear
Secure engine in Installation Position
Remove Intake Filter Housing
Remove Reinforcement Strut (E90/91/92 only)
…