Complete digital official shop manual contains service, maintenance, and troubleshooting information for the BMW 740i/740iL/740Li 1993-2016. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.
This manual for BMW 740i/740iL/740Li 1993-2016 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.
BMW 740iL 1993-2001
BMW 740Li 2011-2015
BMW 740i 1993-2001. 2011-2016
BMW 740Li xDrive 2013-2015
EXCERPT:
1996-2001 ENGINE Engine Mechanical – 740i & 740iL (E38)
Fig. 320: Identifying Central Bolt Position
Unfasten the accessible three screws on exhaust and inlet camshafts on cylinder bank 1 to 4 approx. 1/2 a turn.
Fig. 321: Releasing Screws On Exhaust And Inlet Camshafts On Cylinder Bank 1 To 4
Unfasten the accessible three screws on exhaust and inlet camshafts on cylinder bank 5 to 8 approx. 1/2 a turn.
Fig. 322: Releasing Screws On Exhaust And Inlet Camshafts On Cylinder Bank 5 To 8
Turn over engine once.
CAUTION: Do not turn the engine back. Secure crankshaft with special tool 11 2 300 in TDC position of first cylinder.
Remove special tool 11 2 300 before switching on the engine.
Fig. 323: Removing Special Tool 11 2 300
Fit special tool 11 2 445/441 to camshafts on cylinder bank 1 to 4.
Fig. 324: Installing Special Tool 11 2 445/441 To Camshafts On Cylinder Bank 1 To 4
NOTE: In TDC position of first cylinder, marker bores of camshafts point upwards.
Fig. 325: Identifying Camshafts Marker Bores Position
Fit special tool 11 2 446/442 to camshafts on cylinder bank 5-8.
Fig. 326: Installing Special Tool 11 2 446/442 To Camshafts On Cylinder Bank 5 – 8
NOTE: In TDC position of first cylinder, marker bores of camshafts point upwards.
Fig. 327: Identifying Camshafts Marker Bore Positions
NOTE: When unfastening screw connection on camshaft, brace camshaft on hex head.
CAUTION: Do not damage the cylinder head. If necessary, machine open-end wrench accordingly.
Fig. 328: Releasing Screw Connection On Camshaft
Unfasten remaining three screws on exhaust and inlet camshafts on cylinder bank 1 to 4 approx. 1/2 a turn.
Fig. 329: Releasing Screws On Exhaust And Inlet Camshafts On Cylinder Bank 1 To 4
Unfasten remaining three screws on exhaust and inlet camshafts on cylinder bank 5 to 8 approx. 1/2 a turn.
…