Complete digital official shop manual contains service, maintenance, and troubleshooting information for the BMW 745i, 745Li 2002-2005. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.
This manual for BMW 745i/745Li 2002-2005 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.
745i: 2002-2005
745Li: 2002-2005
EXCERPT:
2002-2005 ENGINE Engine Mechanical – Repair Instructions – 745i
VIBRATION DAMPER
11 23 010 REMOVING AND INSTALLING/REPLACING VIBRATION DAMPER (N62)
Remove alternator drive belt. Refer to 11 28 010 Replacing alternator drive belt (N62).
Remove A/C compressor drive belt. Refer to 11 28 050 Replacing A/C compressor drive belt with belt tensioner (N62).
Remove fan cowl. Refer to 17 11 031 REPLACING FAN COWL (N62) .
Release bolts and remove vibration damper (1).
Fig. 180: Removing Vibration Damper
Installation:
Vibration damper is secured on hub with an alignment pin (4).
Fig. 181: Identifying Alignment Pin
Installation:
Fit bore (2) in vibration damper (1) on alignment pin in hub.
Fig. 182: Fitting Washer
Fit washer (3).
Replace screws.
Tightening torque 11 23 3AZ. Refer to ENGINE – TIGHTENING TORQUES .
11 23 031 REMOVING AND INSTALLING / REPLACING VIBRATION DAMPER HUB (N62 /
N62TU)
Special tools required:
11 3 454
11 3 460
11 9 451
11 9 452
11 9 453
Necessary preliminary tasks:
Remove design cover
Remove fan clutch (E65). Refer to 11 52 020 Removing and installing or replacing fan clutch (N62).
Remove fan cowl (E65). Refer to 17 11 031 REPLACING FAN COWL (N62) .
Remove drive belt for alternator. Refer to 11 28 010 Replacing alternator drive belt (N62).
Remove drive belt for A/C compressor. Refer to 11 28 050 Replacing A/C compressor drive belt with belt tensioner (N62).
Remove front engine under-guard
Remove tensioner from A/C compressor drive belt (E65)
Remove vibration damper. Refer to 11 23 010 Removing and installing/replacing vibration damper
(N62).
Screw special tool 11 9 451 in conjunction with special tool 11 9 452 to vibration damper hub and to oil sump.
Fig. 183: Removing Central Bolt
Release central bolt (1).
Remove special tools.
Remove hub for vibration damper.
Installation:
Check vibration damper hub and radial seal, replace if necessary.
Align groove in vibration damper hub to parallel key and install vibration damper hub.
Replace central bolt (1).
Tighten down central bolt (1) to joining torque.
…