INSTANT DOWNLOAD (add to cart)
Case 821B Loaders Factory Service & Shop Manual
Complete workshop & service manual with electrical wiring diagrams for Case 821B Loaders. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
Case 821B Loaders Service Manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
7-60114 – Case 821B Loaders Service Manual.pdf
1,415 pages, bookmarked, Searchable, Printable, high quality PDF
EXCERPT:
INSPECTION OF THE REVERSE AND SECOND CLUTCHES
1. Check the teeth on the gears for wear and damage. If a tooth is badly damaged, be sure to inspect the gear that is in mesh with the damaged gear. Inspect the splines in the gears for wear and damage. Be sure to inspect the shaft that the gear is installed on.
2. Check the ball, roller and needle bearings for flat areas, pitting and other damage. Check the cages, inner races and outer races for damage also.
3. Check each metal and friction disc with a straight edge to be sure each part is flat. If a metal or friction disc is not flat, a new part must be installed during assembly. If friction discs are smooth or almost smooth, use new parts during assembly. Inspect the metal discs for pitting or scoring or other damage. If there is any damage, use new parts during assembly. Also check the splines for wear.
Inspect the bore and shaft in the clutch housing for damage that will cause leakage when the clutch is assembled. Use new parts as required during assembly.
…