INSTANT DOWNLOAD
Complete workshop & service manual with electrical wiring diagrams for Caterpillar 966 & 966C Wheel Loaders. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This Caterpillar 966 & 966C Wheel Loaders service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
MANUAL LIST:
REG01117 – Disassembly & Assembly (966 Wheel Loader Power Train)
REG01118 – Disassembly & Assembly (966 Wheel Loader Vehicle Systems)
REG01415 – Specifications (966 Wheel Loader Air System & Brakes)
REG01432 – Specifications (966 Wheel Loader Steering System)
REG01437 – Specifications (966 Wheel Loader Power Train)
REG01514 – Specifications (966C Wheel Loader Hydraulic System)
SENR2055 – Disassembly and Assembly (950 & 966C Wheel Loaders Operator’s Station)
SENR5229 – Disassembly and Assembly (Supplement 966C Wheel Loader Transmission)
REG00684 – Disassembly and Assembly (General Instructions).pdf
REG01112 – Systems Operation (966 Wheel Loader Power Train).pdf
REG01112 – Testing & Adjusting (966 Wheel Loader Power Train).pdf
REG01113 – Systems Operation (966 Wheel Loader Steering System).pdf
REG01113 – Testing & Adjusting (966 Wheel Loader Steering System).pdf
REG01114 – Systems Operation (966 Wheel Loader Air System And Brakes).pdf
REG01114 – Testing & Adjusting (966 Wheel Loader Air System And Brakes).pdf
REG01115 – Systems Operation (966 Wheel Loader Hydraulic System).pdf
REG01115 – Testing and Adjusting (966 Wheel Loader Hydraulic System).pdf
REG01248 – Testing & Adjusting (950 & 966 Power Shift Transmission).pdf
EXCERPT:
Wheel Bearing Adjustment
FINAL DRIVE
1. Retainer nut. 2. Wheel. 3. Bearings. 4. Wheel stud.
1. Put an 8.00 in. (203.2 mm) torque wrench on wheel stud (4).
2. Tighten nut (1) while turning wheel (2) to a torque of 160 ± 50 lb. in. (184.5 ± 57.7 cm.kg). This torque reading must be held through one complete revolution of wheel (2). If necessary, do the procedure again to get the correct torque.
3. After getting the correct preload on bearings (3), loosen nut (1). Again, tighten nut (1) while turning wheel (2) to a torque of 75 ± 25 lb. in. (86.5 ± 28.8 cm.kg) for one complete revolution.
4. Turn the nut to the next groove and lock in place.
…