Posted on

JCB 225, 225T, 260, 260T, 280, 300, 300T, 320T, 330 Skid Steer Factory Service & Shop Manual


Pages from 9803-9950 – Skid Steer Large Platform 225, 225T, 260, 260T, 280, 300, 300T, 320T, 330 Service Manual

MJCB225LP330OPES.zip
Price: $29.99 USD

Complete workshop & service manual with electrical wiring diagrams for JCB Skid Steer Large Platform 225, 225T, 260, 260T, 280, 300, 300T, 320T, 330. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This JCB Skid Steer Large Platform 225, 225T, 260, 260T, 280, 300, 300T, 320T, 330 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

9803-9950 – Skid Steer Large Platform 225, 225T, 260, 260T, 280, 300, 300T, 320T, 330 Service Manual.pdf

EXCERPT:
Skid Steer Large Platform
Service Manual – Skid Steer Large Platform
Section 1 – General Information
Section 2 – Care and Safety
Section 3 – Maintenance
Section A – Attachments
Section B – Body and Framework
Section C – Electrics
Section E – Hydraulics
Section F – Transmission
Section J – Tracks
Section K – Engine

Bleeding the System
To bleed the engine fuel filter carry out the following:
1 Make the machine safe with the arm lowered.
Prepare the Machine for Maintenance ( T 3-21)
2 Loosen bleed screw K.
3 Operate the fuel lift pump priming button J until air free fuel exits from the bleed screw.
Catch any excess fuel with a suitable container.
4 Tighten the bleed screw.
!MCAUTION
Running the engine with air in the system could damage the fuel injection pump. After maintenance, the system must be bled to remove any air.
5 The engine is now ready to start. If the engine runs smoothly for a short time and then begins to run roughly, leave at idle until it runs smoothly.
6 If the engine continues to run roughly, check again for air in the fuel system.
7 If the fault persists contact your nearest JCB dealer.