Pages from 9803-6540 – JCB JS330 – Tier II & Tier III Auto Hydraulic Excavator Service Manual
Complete workshop & service manual with electrical wiring diagrams for JCB JS330 – Tier II & Tier III Auto Hydraulic Excavator. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This JCB JS330 – Tier II & Tier III Auto Hydraulic Excavator service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
9803-6540 – JCB JS330 – Tier II & Tier III Auto Hydraulic Excavator Service Manual.pdf
EXCERPT:
Service Manual
JS330 – Tier II and Tier III Auto
Section 1 – General Information
Section 2 – Care and Safety
Section 3 – Routine Maintenance
Section B – Body & Framework
Section C – Electrics
Section E – Hydraulics
Section F – Transmission
Section J – Track and Running Gear
Section K – E
…
Assembly
Assembly is essentially a reverse of the dismantling procedure in the previous section.
Exchange or repair any parts not in accordance with instructions laid down in the Maintenance Standards.
Ensure that all parts are cleaned in the appropriate solvent and dried with compressed air.
Apply a thin film of hydraulic fluid to all sliding parts, bearings and other contact surfaces before assembly.
Replace all O-rings and seals, where appropriate cover with petroleum jelly before fitting.
1 Cylinder block assembly
Assemble spring seat 17, spring 16 and spring seat 15 to cylinder block 4 and fit snap ring 14.
…