Pages from 9803-5100 – JCB Rough Terrain Fork Lift (926, 930, 940) Service Manual
Complete workshop & service manual with electrical wiring diagrams for JCB Rough Terrain Fork Lift (926, 930, 940). It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This JCB Rough Terrain Fork Lift (926, 930, 940) service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
9803-5100 – JCB Rough Terrain Fork Lift (926, 930, 940) Service Manual.pdf
EXCERPT:
Service Manual
Rough Terrain Fork Lift
Section 1 – General Information
Section 2 – Care and Safety
Section 3 – Maintenance
Section A – Attachments
Section B – Body and Framework
Section C – Electrics
Section E – Hydraulics
Section F – Transmission
Section G – Brakes
Section H – Steering
Section K – Engine
…
Removal and Replacement
Removal
1 Before commencing, set machine in straight ahead position on firm level ground. Apply parking brake and stop engine.
2 Remove carriage and forks. K Removal ( T B-15).
3 Disconnect and plug hydraulic hoses 39-A and breather pipe 39-B. View 39-X shows the arrangement for early models whilst view 39-Y shows later models; refer to the view applicable to your machine.
4 Attach a hoist to the top of the mast to prevent mast tipping when tilt rams are disconnected.
5 Support tilt rams. Remove bolts 39-C, washers 39-D and pivot pins 39-E and withdraw tilt rams.
6 Take weight of mast on the hoist. Remove bolts 39-F, pivot pins 39-G and lower mast to ground.
Replacement
The procedure for replacing the mast is a reversal of the removal procedure.
…