INSTANT DOWNLOAD (add to cart)
Complete Repair Technical Manual for John Deere 330CLC and 370C Excavator. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
John Deere 330CLC and 370C Excavator Repair Technical Manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
TM1927 – 330CLC and 370C Excavator Repair Manual.pdf
372 pages, bookmarked, Searchable, Printable, high quality PDF
EXCERPT:
Contents
Foreword
00 – General Information
00 – General Information\0001 – Safety
Avoid Heating Near Pressurized Fluid Lines
Avoid High-Pressure Fluids
Avoid Power Lines
Beware of Exhaust Fumes
Dispose of Waste Properly
Follow Safe Procedures
Handle Chemical Products Safely
Handle Fluids Safely—Avoid Fires
Illuminate Work Area Safely
Keep Riders Off Machine
Live With Safety
Move and Operate Machine Safely
Operate Only from Operator’s Seat
Park Machine Safely
Prepare for Emergencies
Prevent Acid Burns
Prevent Battery Explosions
Protect Against Flying Debris
Protect Against Noise
Remove Paint Before Welding or Heating
Replace Safety Signs
Service Cooling System Safely
Service Machines Safely
Stay Clear of Moving Parts
Support Machine Properly
Use Handholds and Steps
Use Proper Lifting Equipment
Use Tools Properly
Warn Others of Service Work
Wear Protective Clothing
Work in a Clean Area
00 – General Information\0003 – Torque Values
Additional Metric Cap Screw Torque Values
Check Oil Lines And Fittings
Metric Bolt and Screw Torque Values
Service Recommendations for 37° Flare and 30° Cone Seat Connectors
Service Recommendations For Flared Connections—Straight or Tapered Threads
…