INSTANT DOWNLOAD (add to cart)
Kia Spectra/Cerato 2000-2009 Workshop Repair & Service Manual
Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Kia Spectra/Cerato 2000-2009. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.
This manual for Kia Spectra/Cerato 2000-2009 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.
EXCERPT:
2009 ENGINES Engine Mechanical – Spectra & Spectra5
CYLINDER HEAD ASSEMBLY
COMPONENT
Fig. 85: Identifying Cylinder Head Assembly Components With Torque Specifications (1 Of 2)
Fig. 86: Identifying Cylinder Head Assembly Components With Torque Specifications (2 Of 2)
REMOVAL
NOTE: Engine removal is not required for this procedure.
CAUTION: Use Fender cover to avoid damaging painted surfaces. To avoid damaging the cylinder head, wait until the engine coolant temperature drops below normal temperature before removing it. When handling a metal gasket, take care not to fold the gasket or damage the contact surface of the gasket. To avoid damage, unplug the wiring connectors carefully while holding the connector portion.
NOTE: Mark all wiring and hoses to avoid misconnection. Inspect the timing belt before removing the cylinder head. Turn the crankshaft pulley so that the No. 1 piston is at top dead center.
1. Disconnect the terminals (A) from battery and remove the heat shield (B).
Fig. 87: Disconnecting Battery Terminals
2. Remove the engine cover.
Fig. 88: Removing/Installing Engine Cover
3. Remove the radiator cap to speed draining.
4. Loosen the radiator drain plug. and drain engine coolant.
5. Remove the intake air hose and air cleaner assembly.
a. Disconnect the MAF connector (A).
b. Disconnect the breather hose (B) from air cleaner hose (D).
c. Remove the intake air hose and air cleaner assembly (C).
Fig. 89: Removing/Installing Engine Cover
6. Remove the upper radiator hose (A) and lower radiator hose (B).
Fig. 90: Locating Upper Radiator Hose And Lower Radiator Hose
7. Remove the heater hoses (A).
Fig. 91: Removing Heater Hoses
8. Remove the accelerator cable (A) by loosening the lock-nut, then slip the cable end out of the throttle linkage.
Fig. 92: Removing Accelerator Cable
9. Remove the engine wire harness connectors and wire harness clamps from the cylinder head and the intake manifold.
1. OCV (Oil control Valve) connector (A).
2. Oil temperature sensor (OTS) connector (B).
3. Engine coolant temperature (ECT) sensor connector (C).
4. Ignition coil connector (D).
…