Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 2009-2016 Lexus HS 250h. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.
This manual for 2009-2016 Lexus HS 250h is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.
EXCERPT:
2012 Lexus HS 250h
2012 BRAKES Brake System (Front) (Service Information) – HS250H
FRONT BRAKE
COMPONENTS
ILLUSTRATION
Fig. 1: Identifying Front Brake Replacement Components (1 Of 3)
ILLUSTRATION
Fig. 2: Identifying Front Brake Replacement Components With Torque Specifications (2 Of 3)
ILLUSTRATION
Fig. 3: Identifying Front Brake Replacement Components With Torque Specifications (3 Of 3)
REMOVAL
NOTE: When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake pads are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.
HINT:
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
1. PRECAUTION (w/ Navigation System)
NOTE: After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT . Refer to REMOVAL – Step 2
3. DISABLE BRAKE CONTROL . Refer to REMOVAL – Step 3
4. REMOVE FRONT WHEEL
5. DRAIN BRAKE FLUID
6. SEPARATE FRONT FLEXIBLE HOSE
a. Remove the union bolt and gasket, and separate the front flexible hose from the disc brake cylinder assembly.
Fig. 4: Identifying Front Flexible Hose, Disc Brake Cylinder Assembly & Union Bolt
7. REMOVE DISC BRAKE CYLINDER ASSEMBLY
a. Hold the front disc brake cylinder slide pin, and remove the 2 bolts and disc brake cylinder assembly.
Fig. 5: Identifying Front Disc Brake Cylinder Slide Pin, Bolts & Disc Brake Cylinder Assembly