Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 1998-2015 Lexus RX300, RX330, RX350, RX350 F Sport, RX400h, RX450h. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.
This manual for 1998-2015 Lexus RX300, RX330, RX350, RX350 F Sport, RX400h, RX450h is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.
FILELIST (1GB +):
RM1138E – RX400h (MHU38) Service Information Library.zip
RM1138E – RX400H (MHU38) Service Manual.zip
RM1261U – RX450h (GYL10-15) Service Information Library.zip
RX300 Repair Manual
Body Repair Manual
Electrical Wiring
New Car Features
Repair Manual
U140F Automatic Transaxle
RX330 Repair Manual
3MZ-FE Engine Control System (ES)
Air Conditioning (AC)
Automatic Transaxle (AX)
Axle (AH)
Brake Control (BC)
Brake System (BR)
Charging (CH)
Cooling (CO)
Cruise Control (CC)
Differential (DF)
Door Lock (DL)
Drive Shaft (DS)
EM11W2E
EM2260E
Emission Control (EC)
Engine Control System (ECS)
Engine Hood & Door (ED)
Engine Immobiliser (EI)
Engine Mechanical (EM)
Exhaust (EX)
Exterior (ET)
Fuel (FU)
Garage Door Opener (GD)
Horn (HO)
Ignition (IG)
Instrument Panel (IP)
Intake (IT)
Interior (IR)
Introduction (IN)
Lighting (LI)
Lubrication (LU)
Maintenance (MA)
Meter (ME)
MF2A Transfer (TF)
Mirror (MI)
Park Assist & Monitoring (PM)
Parking Brake (PB)
Power Steering (PS)
Propeller Shaft (PR)
Seat (SE)
Seat Belt (SB)
Service Specifications (SS)
Sliding Roof (RF)
Starting (ST)
Steering Column (SR)
Supplemental Restraint System (RS)
Suspension (SP)
Suspension Control (SC)
Theft Deterrent (TD)
Tire & Wheel (TW)
Windshield & Windowglass (WS)
Wiper & Washer (WW)
….
EXCERPT:
ENGINE MECHANICAL
CO/HC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . EM–1
COMPRESSION . . . . . . . . . . . . . . . . . . . . . . . . . EM–3
VALVE CLEARANCE . . . . . . . . . . . . . . . . . . . . . EM–4
IGNITION TIMING . . . . . . . . . . . . . . . . . . . . . . . EM–10
IDLE SPEED . . . . . . . . . . . . . . . . . . . . . . . . . . . . EM–12
TIMING BELT . . . . . . . . . . . . . . . . . . . . . . . . . . . . EM–13
CYLINDER HEAD . . . . . . . . . . . . . . . . . . . . . . . . EM–27
ENGINE UNIT . . . . . . . . . . . . . . . . . . . . . . . . . . . EM–71
CYLINDER BLOCK . . . . . . . . . . . . . . . . . . . . . . . EM–88
EXHAUST SYSTEM . . . . . . . . . . . . . . . . . . . . . . EM–117
ENGINE MECHANICAL – IGNITION TIMING
IGNITION TIMING INSPECTION
1. REMOVE V–BANK COVER
(a) Using a 5 mm hexagon wrench, remove the 3 nuts.
(b) Remove the V–bank cover fastener clip and V–bank cover.
2. WARM UP ENGINE
Allow the engine to warm up to normal operating temperature.
3. CONNECT HAND–HELD TESTER
(a) Connect the hand–held tester to the DLC3.
(b) Please refer to the hand–held tester operator’s manual for further details.
4. CONNECT TIMING LIGHT TO ENGINE
Connect the tester probe of a timing light to the lead wire as shown.
5. CHECK IDLE SPEED
(a) Race the engine speed at 2,500 rpm for approx. 90 seconds.
(b) Check the idle speed. Idle speed: 700 50 rpm
6. INSPECT IGNITION TIMING
(a) Using SST, connect terminals TE1 and E1 of the check connector. SST 09843–18020
(b) Using a timing light, check the ignition timing. Ignition timing: 8 – 12 BTDC @ idle (Transmission in neutral range)
(c) Remove the SST from the check connector. SST 09843–18020
7. FURTHER CHECK IGNITION TIMING
Ignition timing: 10 – 25 BTDC @ idle (Transmission in neutral range)
HINT: The timing mark moves in a range between 10 and 25.
…