Complete workshop & service manual with electrical wiring diagrams for New Holland Backhoe Loaders B110, B115. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This New Holland Backhoe Loaders B110, B115 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
“87643846.pdf”
New Holland Backhoe Loaders B110, B115 Repair Manual
Print No. 87643846
993 pages
COMPLETE HANDBOOK FOR INSTRUCTIONS AND REPAIRS
The complete Service Manual consists of two volumes:
B110 – B115 Service Manual “LOADER BACKHOE”
B110 – B115 Service Manual “Engine”
The Service Manuals for “Loader backhoe” and “Engine” contain the necessary technical information to carry out service and repair on machine and on engine, necessary tools to carry out those operations and information on service standard, on procedures for connection, disconnection, disassembly and assembly of parts.
The complete Service Manual which covers the loader backhoe models B110 – B115 consists of the following volumes, which can be identified through their print number as stated below:
Service Manual – “Loader backhoe” B110 – B115 87643846
Service Manual – “Engine” B110 – B115 87643867
…
— — — — — — — — — — — — — — — — — — — — — — — —
EXCERPT:
SECTION 21 – TRANSMISSION
FIRST CLUTCH ASSEMBLY
Install the clutch piston outer seal.
NOTE: ring must be sized before installing in clutch drum. Sizing is best accomplished by rotating piston while holding a round object against the new sealing ring. Rotate piston until sealing ring is flush with out- er diameter of the piston.
Install the piston inner seal. Install the clutch piston in the clutch drum. Use caution as not to damage the sealing rings.
Install the clutch piston wear sleeve.
Install the piston return disc springs. First spring with large diameter of bevel toward wear sleeve. Alternate eleven (11) springs.
Install the disc belleville washer spring retainer ring.
Compress the spring to install the spring retainer ring.
Be sure ring is in full position in the groove.
Install one outer half disc with friction material away from the piston.
Install one steel disc.
Alternate friction and steel discs until the proper amount of discs are installed.
First and last discs are steel.
…