Posted on

New Holland LS140, LS150, LS160, LS170 Skid Steers Factory Service & Shop Manual


Download Link

INSTANT DOWNLOAD (add to cart)

Complete workshop & service manual with electrical wiring diagrams for New Holland LS140, LS150, LS160, LS170 Skid Steers. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

New Holland LS140, LS150, LS160, LS170 Skid Steers service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

671 pages + 741 pages, bookmarked, Searchable, Printable, high quality PDF

New Holland LS140, LS150 Skid Steers Workshop Manual
Part number 604.13.602 English
New Holland LS160, LS170 Skid Steers Workshop Manual
Part number 604.13.607 English

EXCERPT:
SECTION 88 – ACCESSORIES
Warning Light Bulb Replacement
Amber lens with bulb #9841566
Bulb only #529068
Op. 55 404 10
Front Light
1. Remove the bezel, 1, retaining screws and remove lens from support.
2. Disconnect the wire harness from the bulb holder.
3. Rotate the light bulb holder and element assembly from the lens and remove from the lens.
4. Insert the new bulb into the lens and rotate to lock into position, using caution not to touch the bulb element.
IMPORTANT: Touching the light bulb element may damage the element and cause a premature failure. 64
Op. 55 404 10
Rear Light
1. Remove the bezel, 1, retaining hardware and remove the lens from the light bar.
NOTE: The remaining light lens will be loose in the light bar.
2. Disconnect the wire harness from the bulb holder.
3. Rotate the light bulb holder and element assembly from the lens and remove from the lens.
4. Insert the new bulb into the lens and rotate it to lock into position, using caution not to touch the bulb element.
IMPORTANT: Touching the light bulb element may damage the element and cause a premature failure.