INSTANT DOWNLOAD (add to cart)
Complete workshop & service manual with electrical wiring diagrams for New Holland T5.95, T5.105, T5.115 Tractor . It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This New Holland T5.95, T5.105, T5.115 Tractor service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
2,173 + 1,290 pages, bookmarked, Searchable, Printable, high quality PDF
New Holland T5.95, T5.105, T5.115 Tractor Service Manual
Part number 84568014 English March 2013
New Holland T5 (T5.95, T5.105, T5.115) Tractor Service Manual
1,290 pages English 07/06/2012
T5.95 NA F5DFL413C*A003
T5.95 WE F5DFL413C*A003
T5.95 INT F5DFL413C*A003
T5.105 NA F5DFL413B*A006
T5.105 WE F5DFL413B*A006
T5.105 INT F5DFL413B*A006
T5.115 NA F5DFL413A*A002
T5.115 WE F5DFL413A*A002
T5.115 INT F5DFL413A*A002
…
EXCERPT:
Front axle system – Powered front axle
Four-Wheel Drive (4WD) axle – Remove 4WD
NOTE: The front axle assembly can be removed from the tractor with either the propshaft removed from or installed in the tractor. The description below refers to removal of the front axle with the drive shaft installed on the tractor. For removal of the drive shaft refer to Front-Wheel Drive (FWD) – Disassemble (23.202) .
1. Fold the steps upwards, after operating the retainer (1) . Turn the retainer (2) to remove the battery cover, then detach the negative cable.
2. Unscrew the bolts (1) and remove the front mudguard supports (2).
3. Remove the split pins, lock pins and front ballast (1).
4. Take out the bolts (1) and remove the drive gear shaft guard (2).
5. Remove the circlip (2) and move the sleeve (1) in the direction indicated by the arrow until it is released from the groove on the drive.
6. Attach the front axle to a hoist using two nylon slings.
7. Raise the tractor and position a fixed stand under the engine sump.
8. Unscrew the hoses of the power steering (1) from the fittings of the pipes (2) .
9. Remove the front differential lock fitting (1) and the hose (2) .
10. Unscrew the retaining bolts and remove the front wheels.
11. Take out the front axle rear support retaining bolts (1).
12. Take out the front axle front support retaining bolts (1).
13. Using the hoist and the two nylon slings, one on each side, detach the front axle.
Four-Wheel Drive (4WD) axle – Install 4 WD
1. Position the axle, tighten the front and rear supports to the relative support.
2. Fit the front wheels.
3. Reconnect the differential lock pipe and the power steering pipes.
4. Using the hoist, raise the front part of the tractor.
5. Extract the fixed stand.
6. Remove the nylon slings from the axle.
7. Connect the drive shaft and position the guard.
8. Refit the two front mudguards.
9. Attach a nylon sling to the front ballasting, fit and secure in position with the lock rod.
10. Reconnect the battery negative lead.
11. Tighten to the prescribed torques (see the tightening torques chapter).
…