INSTANT DOWNLOAD (add to cart)
Complete workshop & service manual with electrical wiring diagrams for New Holland TD5.65, TD5.75, TD5.80, TD5.85, TD5.90, TD5.95, TD5.100, TD5.105, TD5.100, TD5.115. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This New Holland TD5.65, TD5.75, TD5.80, TD5.85, TD5.90, TD5.95, TD5.100, TD5.105, TD5.100, TD5.115 service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
1,207 + 678 pages, bookmarked, Searchable, Printable, high quality PDF
84565976A – TC5040, TC5050, TC5060, TC5070, TC5080 Service Manual.pdf
New Holland TD5.65, TD5.75, TD5.85, TD5.95, TD5.105, TD5.115 Tractors Service Manual
1,207 pages PDF
Part number 47445474 English August 2013
New Holland TD5.65, TD5.75, TD5.80, TD5.90, TD5.100, TD5.110 Tractors Repair Manual
678 pages PDF
Part number 47454229 – 10-2012
EXCERPT:
Hydraulic systems – Hydraulic systems
Arm lowering phase
When the operator lowers the position control lever on his right, the return spring (4) pulls spool (1) to the right. Cylinder oil is exhausted under piston pressure (T) through lowering speed adjustment valve (17) and the port uncovered by spool.
Through spool port (F1) and draft sensitivity valve (12) oil flows to piston (9), which holds plunger (5) in the position shown, thus allowing pump delivery to be exhausted past plunger (5).
Unscrewing the screw (16) decreases the load on the spring (15), therefore the valve (14) can vibrate faster, slowing down the descent speed. Tightening the screw (16) slows down the vibration of the valve (14) that increases the descent speed of the arms since the valve (14) can remain in position in correspondence with the larger orifice where the oil fows out from the cylinder. After adjusting the arm descent speed it will not depend on the weight bearing on the arms but will be virtually constant.
Hydraulic systems – Component localization
…