INSTANT DOWNLOAD (add to cart)
Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Nissan Leaf (ZE0) 2011-2016. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.
This manual for Nissan Leaf (ZE0) 2011-2016 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.
EXCERPT:
BODY INTERIOR
INSTRUMENT PANEL ASSEMBLY
< REMOVAL AND INSTALLATION >
REMOVAL
I. Remove instrument lower center cover.
1. Apply protective tape (A) to console finisher assembly to protect from the damage.
2. Apply protective tape (A) around the part to protect from
damage.
3. Insert suitable tool (A) between instrument lower center cover and center console assembly to disengage the metal clips as shown.
4. Lift up instrument lower center cover, then disconnect harness connectors.
CAUTION: Be careful not to scratch console finisher assembly with pawl or metal clip of instrument lower center cover.
II. Remove instrument lower cover LH.
1. Remove clip (A).
2. Pull the instrument lower cover LH crosswise, and disengage the pawls.
CAUTION: Release pawls slowly so that they are not damaged.
III. Remove instrument lower cover RH.
1. Remove clip (A).
2. Pull the instrument lower cover RH crosswise, and disengage the pawls.
CAUTION: Release pawls slowly so that they are not damaged.
IV. Release front pillar portion of front body side welt LH. Refer to INT-29, “BODY SIDE WELT : Removal and Installation”.
V. Remove front pillar garnish LH. Refer to INT-26, “FRONT PILLAR GARNISH : Removal and Installation”.
VI. Remove instrument mask LH.
…