INSTANT DOWNLOAD (add to cart)
Complete workshop & service manual with electrical wiring diagrams for Takeuchi Compact Excavator TB28FR. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This Takeuchi Compact Excavator TB28FR service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
430 pages, bookmarked, Searchable, Printable, high quality PDF
Takeuchi Compact Excavator TB28FR Workshop Manual; 430 pages
EXCERPT:
HYDRAULIC UNITS – TRAVEL MOTOR
d. Install the thrust plate (30).
14. Fit the O-ring (49) on the cover (25) and install it on the housing.
• Align the U-groove in the plug’s hole position.
15. Install the wire (27).
a. Bend the wire (27) at a point approximately 8 mm from the front end, then insert it in the bolt hole in the housing.
b. Turn the cover and wind the wire (27) around it.
• Use the eye bolts and a round bar.
16. Install the plug.
• Wind seal tape around the threads of the plug.
Plug: 7.8 ±1.0 N·m
17. Install the oil seal in the flange holder. • Use pressure fitting jig (H).
18. Install the ball bearing (41) on the shaft (42). • Use pressure fitting jig (I).
19. Install the shaft assembly in the flange. • Use pressure fitting jig (J).
20. Put in the balls and install the spring, piston assembly and swash plate (21).
• Apply hydraulic oil to the sliding surfaces of the swash plate.
21. Assemble the cylinder block assembly.
a. Install the collar, spring and washer in the cylinder block.
b. Install the snap ring.
• Use the installation jig (K).
…