INSTANT DOWNLOAD (add to cart)
Complete workshop & service manual with electrical wiring diagrams for Caterpillar TH255/TH255C Tele-handler. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
These Caterpillar TH255/TH255C Tele-handler manuals (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
MANUAL LIST:
Deutz TCD2.9 Engine (TH255C) Training.pdf
31200362 – Operation & Maintenance Manual (Model TH255).pdf
31200363 – Parts Manual (Model TH255).pdf
31200364 – Service Manual (Model TH255).pdf
31200451 – Service Manual Axle (Models TH255, TH255C).pdf
31200459 – Manuel d’utilisation et de maintenance (Modèle TH255).pdf
31200460 – Manual del operador y de mantenimiento (Modelo TH255).pdf
31200721 – Parts Manual (Model TH255C).pdf
31200746 (SEBU9291) – Operation & Maintenance Manual (Model TH255C).pdf
31200872 (SFBU9291) – Manuel d’utilisation et de maintenance (Modèle TH255C).pdf
31200873 (SSBU9291) – Manual del operador y de mantenimiento (Modelo TH255C).pdf
31200927 – Service Manual (Model TH255C).pdf
31200934 – Engine Parts Manual (Model TH255C).pdf
31200980 – Engine Service Manual (Model TH255C).pdf
31211008 – Axle Service Manual (Models TH255, TH255C).pdf
…
EXCERPT:
7.7.2 Exhaust System Installation
Note: Keep all clamps loosened until entire exhaust system is in place.
Note: Replace the nuts and the exhaust studs on the turbocharger if damaged.
1. Install the exhaust assembly in place at the turbocharger with the previously used hardware.
Torque the flange nuts (2) on the turbo charger to 22 ±5 lb-ft (30 ±7 Nm).
2. Install the muffler brackets (1) to the frame brackets with the previously used hardware.
3. Adjust the muffler, exhaust and tail pipes for proper clearance then tighten all clamps.
4. Properly connect the battery. Refer to Section 9.8, “Battery”, for procedure.
5. Start engine and check for exhaust leaks at all exhaust connections. Adjust or repair as needed.
6. Close and secure the engine cover.
7. Remove the Do Not Operate Tags from both the ignition key and the steering wheel.
…