Posted on

JCB 3000 XTRA Series Fastrac Factory Service & Shop Manual


Pages from 9803-9970 – JCB 3000 XTRA Series Fastrac Service Manual

MJCB3000XTRAOPES.zip
Price: $29.99 USD

Complete workshop & service manual with electrical wiring diagrams for JCB 3000 XTRA Series Fastrac. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.

This JCB 3000 XTRA Series Fastrac service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.

9803-9970 – JCB 3000 XTRA Series Fastrac Service Manual.pdf

EXCERPT:
Service Manual
3000 XTRA Series Fastrac
Section 1 – General Information
Section 2 – Care and Safety
Section 3 – Routine Maintenance
Section A – Hitches and Attachments
Section C – Electrics
Section E – Hydraulics
Section F – Transmission
Section G – Brakes
Section H – Steering
Section S – Suspension
Section T – Engine

Transmission
Checking the Transmission Oil Level
1 Park the machine on firm, level ground. Engage the park brake. Lower the equipment. Stop the engine.
2 Check that oil is at the top mark on dipstick X. Add recommended oil, if necessary, at filler Y. K Fluids, Lubricants and Capacities, Fuel ( T 11)
After topping up, run the engine for 1 minute, then stop the engine and allow to stand for 2 minutes before re-checking the level.
Note: Do not overfill as this would cause oil to be forced past the oil seals and out of the gearbox.