INSTANT DOWNLOAD (add to cart)
Complete workshop & service manual with electrical wiring diagrams for 2006-2017 Mitsubishi Pajero/Montero, Montero Sport/Pajero Sport. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This 2006-2017 Mitsubishi Pajero/Montero, Montero Sport/Pajero Sport service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail.
’06 Montero
’07 Pajero (MUT-III)
’08 Pajero (MUT-III)
’09 Pajero (MUT-III)
’09 Pajero Sport (MUT-III)
’10 Pajero (MUT-III)
’10 Pajero Sport (MUT-III)
’11 Pajero (MUT-III)
’11 Pajero Sport (MUT-III)
’12 Pajero (MUT-III)
’13 Pajero (MUT-III)
’14 Pajero Sport (MUT-III)
’15 Pajero (MUT-III)
’16 Pajero (MUT-III)
…
EXCERPT:
MITSUBISHI MONTERO 2006 SERVICE MANUAL
GROUP INDEX
General . . . 00
Engine . . . 11
Engine Lubrication . . . 12
Fuel . . . 13
Engine Cooling . . . 14
Intake and Exhaust . . . 15
Engine Electrical. . . 16
Engine and Emission Control . . . 17
Automatic Transmission . . . 23
Propeller Shaft . . . 25
Front Axle . . . 26
Rear Axle . . . 27
Wheel and Tire . . . 31
Power Plant Mount . . . 32
Front Suspension . . . 33
Rear Suspension . . . 34
Alphabetical Index . . . INDEX
…
REMOVAL SERVICE POINTS
< > DRIVE BELT AUTO TENSIONER REMOVAL
The following operations will be needed due to the introduction of the serpentine drive system with the drive belt auto tensioner.
1.Insert a 12.7 mm (1/2 inch) breaker bar into the square hole on the drive belt auto tensioner, and rotate it clockwise until the tensioner touches the stopper.
2.Align hole B with hole A, and insert a 5.0 mm (0.20 inch) Allen wrench to hold the tensioner. Then loosen the drive belt, and then remove the drive belt auto tensioner.
< > POWER STEERING OIL PUMP ASSEMBLY / A/C COMPRESSOR ASSEMBLY REMOVAL
1.Do not disconnect the hoses to remove the pump and compressor.
2.Support the removed pump and compressor with a wire, etc. so that they will not get in the way while working.
<
Use special tools MB991800 and MB991802 to remove the crankshaft pulley from the crankshaft.
…