INSTANT DOWNLOAD (add to cart)
Complete workshop & service manual with electrical wiring diagrams for New Holland T6.120, T6.140, T6.140 AutoCommand, T6.150, T6.150 AutoCommand, T6.155, T6.160, T6.160 AutoCommand, T6.165, T6.175 Tractors. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This New Holland T6.120, T6.140, T6.140 AutoCommand, T6.150, T6.150 AutoCommand, T6.155, T6.160, T6.160 AutoCommand, T6.165, T6.175 Tractor service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
3,823 pages, bookmarked, Searchable, Printable, high quality PDF
New Holland T6.120, T6.140, T6.140 AutoCommand, T6.150, T6.150 AutoCommand, T6.155, T6.160, T6.160 AutoCommand, T6.165, T6.175 Tractor Service Manual
3,823 pages PDF
Part number 47665859 English February 2014
T6.120, T6.140 AutoCommand, T6.140, T6.150 AutoCommand, T6.150, T6.155, T6.160 AutoCommand, T6.160, T6.165, T6.175
EXCERPT:
Hydraulic systems – Reservoir, cooler, and filters
1. Remove the filter guard bracket by unscrewing the three retaining bolts.
2. Before changing the main filter cartridge in housing (3) Figure 2 , release the air bleed valve (2) by unscrewing fully. This will allow air into the filter so that most of the oil can drain back to the reservoir. Wait a few moments and then remove the 19 mm plug (5) from the filter casing and allow the oil to drain out into a suitable container.
3. Using as 41 mm socket or ring spanner, remove the filter support plate by turning approximately 45 ° to the left. Remove filter and plate.
4. Ensure support plate is clean before installing the new cartridge. Lightly oil the sealing ring and refit the assembly to the filter housing, making sure that plate locks into place and the lug (4) aligns correctly with the arrow on the filter casing.
NOTE: When replacing the main filter cartridge the bottom cover sealing ring must also be replaced.
5. Unscrew the charge filter (1) and discard in an appropriate container.
6. Clean the inlet channel and the face of the filter mounting.
Smear clean oil around the rubber seal of the new filter and install into the filter housing. Screw up until the faces just meet, then tighten a further 3/4 of a turn.
Do not over-tighten.
Oil filters – Remove Filter Assembly
1. Remove the hydraulic oil filter vent cap.
NOTE: Leave for one minute to allow oil in the filters to drain into the sump.
2. Remove the filter housing guard bolts (1) and remove the guard.
3. Remove the filter housing drain plug and drain the oil.
NOTE: Place a suitable container under the oil filter housing to collect the hydraulic oil.
…