INSTANT DOWNLOAD (add to cart)
Toyota Avensis 2002-2009 Workshop Repair & Service Manual
Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Toyota Avensis 2002-2009. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your Avensis like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.
This manual for Toyota Avensis 2002-2009 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.
MAKE: Toyota
YEAR: 2003 2004 2005 2006 2007 2008 2009
MODEL: Avensis (ZZT250, ZZT251, AZT250, AZT251, CDT250 Series)
FORMAT: PDF
New Car Features
Repair Manual
Engine Repair Manual
M/T Repair Manual
A/T Repair Manual
Electrical Wiring Diagrams
Body Repair Manual for Collision Damage
Service Data Sheet
…
EXCERPT:
POWER STEERING – POWER STEERING SYSTEM
ON–VEHICLE INSPECTION
1. INSPECT DRIVE BELT
(a) Visually check the belt for excessive wear, frayed cords, etc.
If any defect is found, replace the drive belt.
HINT: Cracks on the rib side of a belt are considered acceptable. If the missing chunks from the ribs are found on the belt, it should be replaced.
2. BLEED POWER STEERING SYSTEM
(a) Check the fluid level.
(b) Jack up the front of the vehicle and support it with the stands.
(c) Turn the steering wheel.
(1) With the engine stopped, turn the wheel slowly from lock to lock several times.
(d) Lower the vehicle.
(e) Start the engine.
(1) Run the engine at idle for a few minutes.
(f) Turn the steering wheel.
(1) With the engine idling, turn the wheel to right full lock position and keep it there for 2 to 3 seconds, then turn the wheel to left full lock position and keep it there for 2 to 3 seconds.
(2) Repeat (1) several times.
(g) Stop the engine.
(h) Check for foaming or emulsification. If the system has to be bled twice specifically because of foaming or emulsification, check for fluid leaks in the system.
(i) Recheck the fluid level.
3. CHECK FLUID LEVEL
(a) Keep the vehicle level.
(b) With the engine stopped, check the fluid level in the oil reservoir. If necessary, add fluid. Fluid: ATF DEXRON II or III
HINT: If the fluidis hot, check that the fluid level is within the HOT LEVEL range on the oil reservoir. If the fluid is cold, check that it is within the COLD LEVEL range.
(c) Start the engine and run it at idle.
(d) Turn the steering wheel from lock to lock several times to boost fluid temperature.
Fluid temperature: 80C (176F)
(e) Check for foaming or emulsification.
If there is foaming or emulsification, bleed the power steering system.
(f) With the engine idling, measure the fluid level in the oil reservoir.
…