INSTANT DOWNLOAD (add to cart)
Complete workshop & service manual with electrical wiring diagrams for JCB Micro, Micro Plus, 8008, 8010 Excavator. It’s the same service manual used by dealers that guaranteed to be fully functional and intact without any missing page.
This JCB Micro, Micro Plus, 8008, 8010 Excavator service & repair manual (including maintenance, overhaul, disassembling & assembling, adjustment, tune-up, operation, inspecting, diagnostic & troubleshooting…) is divided into different sections. Each section covers a specific component or system with detailed illustrations. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. The printer-ready PDF documents work like a charm on all kinds of devices.
FILELIST:
9803-9310 – JCB Micro, Micro Plus, 8008, 8010 Service Manual.pdf
Machine Model and Serial Number
This manual provides information for the following
model(s) in the JCB machine range:
– Micro from serial number M1148300
– Micro Tier 3 from serial number M1149553
– Micro Plus from serial number M1007000
– Micro Plus Tier 3 from serial number M1007129
– Micro 8008 from serial number M1239500
– Micro 8010 from serial number M1149553
Note: The JCB Micro Excavator is available in a number of different TOPS, FOPS and roofing configuration. These different configurations are reflected in the illustrations used in this handbook.
EXCERPT:
Machine Cycle Times
Test Machine Cycle Times
Note: It is easier if two persons do this task- one person to operate the controls and one person to record the machine cycle times.
!MWARNING
If two people are doing this job make sure that the person working the controls is a competent operator.
If the wrong control lever is moved, or if the controls are moved violently, the other person could be killed for injured.
1 Warm the engine to Increase the temperature of the hydraulic system to 50 degrees C.
2 Operate each service through it’s full travel 10 times to make sure that the warm oil is circulated through the engine.
3 When the hand controller lever is fully set, use a stopwatch to time each service from the start to the end of travel.
4 Do this task five times and make a record of the average of these readings.
Note: If the machine is installed with HBCV’s and there is a delay between the selection of the hand controller and movement of the cylinder:
– Open the bleed nipple on the HBCV and select the service to bleed the pilot signal to check valve, then repeat the cycle times.
…