Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 2005-2013 Beta RR 4T 250/400/450/525 Four Stroke. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your bike like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.
This manual for 2005-2013 Beta RR 4T 250-400-450-525 Four Stroke is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.
EXCERPT (2005-2013 Beta RR 4T 250-400-450-525 Four Stroke Motorcycle Service/Repair Manual):
GENERAL CONTENTS
Generalinformation
Specific tools
Tightening torques – Specifications – Recommended products
Maintenance
Bodywork and fittings
Engine
Carburetor
Front suspension/wheel
Rear suspension/wheel
Braking system
Electrical system
Cleaning the short oil unit
Short oil unit 1 is fitted into socket-head screw 2 on the lower side of the engine. Insert an Allen key into the socket and unscrew the oil drain screw.
Remove the oil unit, thoroughly clean its components and blow them with low-pressure compressed air. Check the O-rings for damage and if necessary replace them.
Replace the oil unit with the screw and tighten the latter to 10 N·m.
Cleaning the long oil unit
The long oil unit is fitted into hexagonal-head screw 3 next to the engine number. Remove the screw with the oil unit, thoroughly clean the components and blow them with low-pressure compressed air. Check the O-rings for damage and if necessary replace them.
Carburettor – Idle speed adjustment
The adjustment of the idle speed strongly affects engine start- ing, i.e. an engine whose idle speed is properly adjusted is easier to start than an improperly tuned engine.
The idle speed is adjusted by means of adjusting roller 1 and mixture adjusting screw 2. The adjusting roller alters the base position of the throttle valve; the mixture adjusting screw adjusts the idle speed mixture, which comes to the engine through the idle speed system. Turning the screw clockwise decreases the quantity of fuel (lean mixture); turning it anti-clockwise increases the quantity of fuel (rich mixture).
To properly adjust the idle speed, follow these steps:
– Turn in mixture adjusting screw 2 until it stops, then turn it to obtain the basic adjustment prescribed by BETAMOTOR (see engine specifications in Chapter 3).
– Warm up the engine.
– Using adjusting roller 1, adjust the standard idle speed (1400- 1500 rpm).
– Slowly turn mixture adjusting screw 2 clockwise until the idle speed begins to decrease. Memorise this position. Now slowly turn the mixture adjusting screw anticlockwise until the engine speed starts to decrease again. Choose the point between these two positions where the idle speed is higher. Should the engine speed increase considerably, reduce it to the standard level and repeat the above procedure.
…
